Go back

Pro Line 1620 FLEX(S)

Spooling / slitting machine. Width: 1620 mm

Description

Product highlights:

Designed specifically for the hot stamping foil distributing industry.
Machine produces good quality rolls in terms of rewind tension and roll edge profile at speeds up to 400 metres per minute.
Accommodates jumbo rolls two with a diameter of max. 1.000 mm and 1620 mm wide.
Rewind shafts with individual motors and clutch system that gives you the advantage of independent control of tension on each rewind shaft, thus making combined spooling/slitting of rolls with different diameter possible.

Tension control is fully automatic actual tension via load cells.

Machine options:

Specification:

UNWIND

Unwind type:	3inch / 6 inch� shaft size none-pickup from floor
Maximum roll width:	Up to 1620mm
Minimum roll width:	100mm on 3inch / 6 inch
Maximum roll diameter:	1000mm
Core size:	3inch / 6 inch
Core holding:	Compress to grip dual size mechanical chuck
Brake:	Electrical powder
Shaft supplied:	1x 3inch

MAIN DRIVE

Main drive:	Dual 100mm diameter “S� wrap diamond pattern rubber covered drive rollers
Main drive motor:	7.5Kw AC Vector type with encoder and cooling fan
Maximum machine speed:	400 metres/min
Length counter:	Calibrated in metres. This system only requires a length input from the operator as the PLC system automatically calculates the slowdown point to stop at final length

SLITTING STATION

Slitting type:	Individual razor blades in air
Razor comb in / out control:	Pneumatically operated with fine depth adjuster
In-feed slitting roller:	Specially grooved rubber roller that removes any creases in the product before it enters the slitting section. This roller is driven
Out-feed slitting roller:	Driven diamond pattern rubber covered
Trim removal (optional):	Dual trim winders

REWIND

Rewind motors:	2x 7.5Kw AC Vector type with encoders and cooling fans
Maximum rewind width:	Up to 1620mm
Maximum rewind diameter:	450mm standard, 500mm optional
Minimum shaft size:	1inch
Shafts supplied:	2 x 1inch shafts (standard) + 2 x 3inch air shafts (optional)
Minimum slitting width:	10 mm
Tension control:	Independent automatic load cell control of each rewind station (lock core winding)
Tension range:	0.2 – 25 kg per shaft
Lay-on arms:	Pneumatically controlled full width anti-static 40 degrees shore rubber lay-on rollers
Shaft support: Optional	One set of 1inch clamping shafts incl. supports to enable full width slitting on 1inch ID cores (photo 7)
Finished roll unloading tree:	Four shafted fixed position unit with 2x 3inch shafts and 2x 1inch shafts for material unloading
Operator interface:	10,4inch colour touch screen that controls all machine speeds and tensions.

MATERIALS BUILD UP

Main machine frames:	40mm thick stress relieved certified plates
All steel work:	Either electroplated or powder coated to prevent corrosion
Path rollers:	Steel tube, balanced
Drive rollers:	100mm diameter solid steel rubber covered with diamond pattern
Roller bearings:	SKF
Linear slide rails:	SKF
AC Vector motors:	Siemens
AC Vector controllers:	Siemens
AC servo equipment:	Brook (Trim winders)
PLC equipment:	Siemens
Touch screen:	Mitsubishi

Enquiry

Did you know that Starfoil is a supplier of make-ready materials?

• Toggle hooks, keys en bits
• Pertinax
• Presspan
• Epoxy glass board
• Yellow cover board
• Rubber Printbase
• SuperPress blanket
• Diafoil